And the Honda 150 engine also runs just fine, and is being used to drive a home-constructed sawmill.In early May I asked questions at this forum in regard to my Pentron tube open reel stereo Hi-Fi system. So yes, the selenium rectifier is still functional. This is the measurement of one of the three diodes: the other two have a similar characteristic. The reverse characteristic shows a reverse current of 800uA or so up to a reverse voltage of 30 volts, also very respectable. Switching on the measurement cursors, the forward resistance over the linear region is 0.37 ohms. Unlike a multimeter test, the curve tracer exercises the device under test over a range of voltage and currents, so it’s a much more informative measurement.Īs you can see from the graph, the forward characteristic is a classic diode curve with a threshold about 0.2 volts, increasing to 0.8 volts at 1 amp forward current. So we connected it to a CTR-101 curve tracer to run the forward characteristic curve. The forming current is a minimum current to regenerate the proper operation. The Wikipedia page on Selenium Rectifier mentions that a ‘forming current’ may be required after a long period of disuse, and long period of disuse applies in this case: it had been out of service 40 years or more. Was the selenium rectifier still good? We measured the forward and reverse resistance with a multimeter, and the results were inconclusive. The owner of the bike had replaced the selenium rectifier with a modern three-phase silicon diode array, a much smaller and probably more efficient device. The rectifier consists of three diodes with one common terminal, so that the output is a reasonable approximation of direct current. The alternator is wired to produce 3 sine wave outputs, each 120 degrees apart. We were given a three-phase selenium rectifier, taken from an ancient Honda 150 motorcycle. Selenium rectifiers are recognizable by the cooling fins, which are often painted green or orange. The selenium rectifier replaced the vacuum tube rectifier in the period 1950 onward and was in use until the 70’s. Before the invention of the silicon diode, designers had the choice of germanium point contact diodes for low currents, copper-oxide rectifiers in instruments, and selenium rectifiers for power applications.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |